Overview:
The Solid-State output interfaces to a system controller, which is pre-programmed for a specific sequemce of tasks. Mounted in or near each bin in an assembler's work station, the sensor job light signals the assembler
Which bins contain items to be picked in a given operation; and
In what order they should be picked
As the assembler takes a part in sequence, the sensor senses that the part was removed and it sends an output signal to the controller. The controller then verifies if the correct part was taken and may respond by turning that job light OFF, activating the job light of the next bin in the sequence.
If multiple parts are to be removed from one bin, the job light may remain ON until the appropriate number of signals is returned to the controller. If an incorrect part is selected, the control system may be wired to signal an alarm for the assembler and/or a supervisor, or it may be programmed to interpret the action as a call for parts.
Features: Rugged, Cost-effective and easy-to-install multicolor indicator light with push button
Illuminated dome provides an easy-to-see green job light; some models also light red for alternate operation
Waterproof IP65 construction for washdown environments
Compact devices are self-contained - no controller needed
Immune to EMI and RFI interference
12 to 30V dc operation
Cabled and Quick Disconnect models available
 Download the
EZ-Light K30 Series Pick-to-Light Sensors
Data Sheet in *.pdf format.
|
|
